Polaris 600 RMK Shift Bedienungsanleitung PDF herunterladen (Seite 108)

105

MAINTENANCE

Steering System

n Ski Skags

Check skags before each use of the snowmobile to ensure positive steer-

ing characteristics. Skags must be replaced when worn to half their orig-

inal diameter. Carbide skags must be replaced if any abnormal wear or

chipping is found.

Skag Replacement

Some models are equipped with single skags. Other models are

equipped with dual skags.

1. Raise and support the front of

the snowmobile so the skis

are approximately 6" (15 cm)

from the ground.

2. Remove the attaching nuts

and pry the skag downward.

3. Remove the front end of the

skag.

4. Remove the rear end of the

skag.

5. Reverse the steps to install a

skag.

WARNING

Worn skis and/or skags will adversely affect handling. Loss of vehicle control

may result, causing serious injury or death.

See your dealer's studding chart for recommended skags. If you install longer

or more aggressive carbide skags than the original equipment, it may also be

necessary to add track studs to maintain proper vehicle control while turning

on hard-packed snow or ice.

Skag

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 132 133

Keine Kommentare

Polaris 600 RMK Shift Bedienungsanleitung Seite 108